Chuo, Wen Ho
Statistical optimization and stability study of quercetin-loaded microemulsion - Vol.13(1) - M P Innovare Academic Sciences Pvt Ltd 2021 - 23-35p.
Objective: This research aims to develop a quercetin microemulsion system to improve the solubility of quercetin and to study the stability of the microemulsions. Methods: The microemulsion is prepared by water titration method using isopropyl myristate (oil), Tween 60®/Span 80® (3:2) (surfactant) and ethanol (co-surfactant). Two different aqueous phases, water or NaCl solution, were used to prepare microemulsions and the influence of each parameter was described. DPPH scavenging and anti-tyrosinase activity were performed along with chemical stability to evaluate the functional stability of microemulsions. Results: The influence of percentage of oil phase (variable A) on the solubility of quercetin was less significant than that of percentage of surfactant/co-surfactant (variable B). Compared to those prepared with water (variable C), the solubility of quercetin in microemulsions prepared with NaCl solution significantly increased. The ratio of the high level to low level for solubility of three variables was 1.135, 1.315 and 1.591 respectively. Increasing variable A and B led to an increase in the particle size of microemulsions from 120.08 nm to 188.38 nm and 48.18 nm to 260.28 nm, respectively. The influence of variable B was quite significant, while variable C has no significant effect on particle size. Quercetin microemulsions showed good chemical and functional stability when stored at 4 °C. Under other conditions, especially at 40 °C, the activity of the microemulsion is considerably reduced. Conclusion: The influence of different variables on the characteristics of microemulsions was complicated. Care must be taken in the composition and storage conditions of these formulations.
PHARMACEUTICS
Statistical optimization and stability study of quercetin-loaded microemulsion - Vol.13(1) - M P Innovare Academic Sciences Pvt Ltd 2021 - 23-35p.
Objective: This research aims to develop a quercetin microemulsion system to improve the solubility of quercetin and to study the stability of the microemulsions. Methods: The microemulsion is prepared by water titration method using isopropyl myristate (oil), Tween 60®/Span 80® (3:2) (surfactant) and ethanol (co-surfactant). Two different aqueous phases, water or NaCl solution, were used to prepare microemulsions and the influence of each parameter was described. DPPH scavenging and anti-tyrosinase activity were performed along with chemical stability to evaluate the functional stability of microemulsions. Results: The influence of percentage of oil phase (variable A) on the solubility of quercetin was less significant than that of percentage of surfactant/co-surfactant (variable B). Compared to those prepared with water (variable C), the solubility of quercetin in microemulsions prepared with NaCl solution significantly increased. The ratio of the high level to low level for solubility of three variables was 1.135, 1.315 and 1.591 respectively. Increasing variable A and B led to an increase in the particle size of microemulsions from 120.08 nm to 188.38 nm and 48.18 nm to 260.28 nm, respectively. The influence of variable B was quite significant, while variable C has no significant effect on particle size. Quercetin microemulsions showed good chemical and functional stability when stored at 4 °C. Under other conditions, especially at 40 °C, the activity of the microemulsion is considerably reduced. Conclusion: The influence of different variables on the characteristics of microemulsions was complicated. Care must be taken in the composition and storage conditions of these formulations.
PHARMACEUTICS